A performance chip is an aftermarket auto part that enhances your car’s performance by adjusting the engine’s parameters managed by the computer. The chip helps the computer to regulate and increase the engine’s energy, giving it a turbo boost. These chips are featured in additional modern vehicles today. Performance chips are easy to install by merely eradicating the unique chip and changing it with the performance chip.
Honda Performance Chips Installation Instructions
1. Loosen the nuts that maintain the detrimental and constructive battery cables with a socket wrench then disconnect the cables. You might want a socket wrench extender if you cannot reach the nuts. Find the Intake Air Temperature Sensor (IATS). This element is on the air tube in front of the throttle body and behind the air box. Disconnect the IATS. If this component is shared with the mass air movement sensor, discover the mass air flow sensor and remove the positive and damaging wires that handle the IATS.
2. Disconnect the battery whereas the harness is plugged in. The one purpose to unplug the harness is in case you are testing its wires to determine which of them are optimistic and negative. Check the voltage while the battery continues to be connected. Then remove the battery once you determine the voltage.
3. Plug the performance chip into the newly uncovered holes within the mass air stream sensor. Fasten the wires in place with silicone or tape. Reconnect the battery. Begin the motor and maintain it at 2,000 RPM for approximately 30 to forty five seconds. The Honda’s laptop will reprogram the ECU. Wait 5 to 10 minutes before driving the vehicle.